|
|
|
NOTE!
This is a real-time comments system. As such, it's also a
free speech zone within guidelines set forth on the Post
Comments page. Opinions expressed here may or may not
reflect those of KeepAndBearArms staff, members, or
any other living person besides the one who posted them.
Please keep that in mind. We ask that all who post
comments assure that they adhere to our Inclusion
Policy, but there's a bad apple in every
bunch, and we have no control over bigots and
other small-minded people. Thank you. --KeepAndBearArms.com
|
The
Below Comments Relate to this Newslink:
Pistol ammo, part 2
Submitted by:
Mark A. Taff
Website: http://www.marktaff.com
|
There
is 1 comment
on this story
Post Comments | Read Comments
|
Last time, we started off by talking about the nuts and bolts of handgun ammunition. Today we’re picking up that discussion where we left off.
Handgun ammo is generally made for use in pistols or revolvers. Yes, a revolver is technically a pistol, but I’m talking about semi-automatic pistols. There is a difference between the two. In a revolver round, the base or rim of the cartridge is larger in diameter than the case. If it wasn’t, the rounds would simply fall through the revolver’s cylinder. |
| Comment by:
PHORTO
(9/17/2020)
|
No, a revolver is not technically a pistol. It is designed to use with one hand, and folks have taken to call it a pistol. It is generically a 'pistol,' but technically it is not.
But a pistol's chamber and barrel are one piece. A revolver's are not; there is a "cylinder gap" separating the two. |
|
|
| QUOTES
TO REMEMBER |
| Congress have no power to disarm the militia. Their swords, and every other terrible implement of the soldier, are the birthright of an American... The unlimited power of the sword is not in the hands of either the federal or state government, but, where I trust in God it will ever remain, in the hands of the people. — Tench Coxe, Pennsylvania Gazette, Feb. 20, 1788. |
|
|
